IEC 60623 PDF
IEC/EN Title: Secondary cells and batteries containing alkaline or other non-acid electrolytes – Vented nickel-cadmium prismatic rechargeable single. IEC Secondary cells and batteries containing alkaline or other non-acid electrolytes – Vented nickel-cadmium prismatic rechargeable single cells. IECEE Certification & Testing | IEC Standards | IEC | General Information.
|Published (Last):||26 November 2014|
|PDF File Size:||17.3 Mb|
|ePub File Size:||9.86 Mb|
|Price:||Free* [*Free Regsitration Required]|
Variations of those profiles for seasons could be considered if having a significant impact on the load profile. Secondary cells and batteries IEC all partsDirect acting indicating analogue electrical measuring instruments and their accessories IECSampling plans and procedures for inspection by attributes IEC all parts iev, Graphical symbols for use on equipment IECDigital electronic d. Classification of groups of environmental parameters and their severities; section 2: Secondary cells and batteries containing alkaline or other nonacid electrolytes – Safety requirements for portable iwc secondary cells, and for batteries made from them, for use in portable application.
If acceptable by the customer ieec may be sufficient to do the worst case only. Note 2 the nominal voltage of a battery of n series connected cells is equal to n times the nominal voltage of a single cell.
IEC Standard – Home
Electronic equipment used on rail vehicles IEC A risk evaluation and assessment provides the necessary safety integrity level SIL for each function and finally each component. Railway application – Environmental conditions for equipment. Especially the annex 4. For example a battery standard can allow a relative wide range of voltage, but due to the direct connection to a train safety system this range is diminished by another standard.
The latter should be applied for electric Li-ion railways batteries 66023 batteries, EDLCs or flywheels as these Li-ion railways batteries interfere with existing technologies like traction converters, what for the standards have 606223 written.
It has a battery management unit to cut off in case of over charging, over current, and over heating. Clearances and creepage distances for all 60263 and electronic equipment EN The battery shall not be exposed to direct sunlight.
Alternating Current Direct Current Voltage.
Need of a new application standard of traction batteries, especially Lithium-Ion, for TC9 was identified. The hierarchy of the standards is intended to be as follows in Railway specific area: Definitions IEC The latter were included due to the 60632 of explosive gases H2 and O2 which can occur with lead acid batteries. Nevertheless national authorities may decree national rules how to apply it.
Develop, test and integrate batteries according to the standards
Railway applications — Electronic power converter for rolling stock IEC Railway application – Electromagnetic compatibility all partsespecially the IEC 6. It incorporates adequate housing and a terminal arrangement and may have protective devices or circuits.
Railway Applications – Software for railway control and protection systems 6. This can be done through numerical calculation e. Moreover, their result is an entrance 606223 for battery sizing.
IEC System of Conformity Assessment Schemes
Considering France, it exist many railway regulations applicable to EES that could be relevant in this study. Low-voltage installations – Part This process requires a well defined and harmonised methodology for specification and verification of the load profile compliance as contractually defined.
This should accompany the batteries. Although Li-ion batteries show a much lower risk of producing explosive gases, at the moment the complying with this regulation has to be discussed with the EBA, as there are no rail standards for this topic.
Reference source not found. Railway applications – Electric equipment for rolling stock – Part 2: Regulation EN gives the requirement to guarantee quality of voltages supplied by the storage system. Secondary cells and batteries containing alkaline or other non-acid electrolytes — Large format secondary lithium cells and batteries for use in industrial applications, 13 14 15 IEC It shall be done accordingly to chapter Works done from then led to the following standards under construction: They are detailed in the following sub-capters.
As an option, such cells or batteries could be identified 606223 such with mention of the class of cycle rating for those cells. Tests – Test B: It is therefore necessary to have a clear definition of the different profiles, as well as of their expected repetition over daily operation with possible insertion of emergency profile at some point. Insulating materials – Industrial rigid laminated sheets based on thermosetting resins for electrical purposes – Part 1: It is not ready for use in an application since it is not yet fitted with its final housing, terminal arrangement and electronic control device.
Rules for installation of cabling. The test shall not start before reaching the testing temperature for at least 1 idc.
Therefore, they will not be mentioned in the following parts. Secondary cells and batteries containing alkaline or other non-acid electrolytes — Safety requirements for large format secondary lithium cells and batteries for use in industrial applications.